Product Information TM IMP1A 3U CompactPCI Processor with Certifiable BSP to DO-178B Level A High Performance 3U CompactPCI Processor CompactPCI System Slot or Peripheral Slot PowerPC 7410 to 500 MHz and beyond On-board PMC site Up to 2 Megabyte (MB) L2 Cache Up to 128 MB SDRAM 64 MB FLASH Two fast Sync/Async serial ports Two 10/100 BASE-T Ethernet ports Up to 12 bits GPIO Designed for demanding applications with restrictive dimensional requirements, IMP1A packs a powerful SBC into an extremely space efficient 3U form factor. Radstone’s 40 years of experience in the defense electronics market have been coupled with their continued investment in PowerPC technology to produce a highly effective solution for the most rigorous of requirements. Available with either PowerPC 7410 processor IMP1A is based around a Marvell Discovery Integrated System Controller which combines high- performance system control with multiple communication peripherals including high-speed serial and Ethernet ports, all on a single chip. A range of I/O options are offered including up to 2 Ethernet channels, up to 12 bits of discrete digital I/O, and up to 2 serial channels capable of high-speed operation in either asynchronous or synchronous mode and software programmable as RS232/422 or 485. In addition to deployed test software and a range of BSP support for standard (non certifiable) COTS operating systems, the IMP1A is supported by a BSP for the certifiable VxWorksAE653 operating system from Wind River Systems. Features Features Details System or Peripheral slot Support for up to 7 peripheral slots IMP1A detects a backplane signal to configure in System Slot or Peripheral Slot mode Processor PowerPC 755 at 400 MHz The 755 is Freescale’s long term supported part from its well established and performant G3 family of processors (SPECInt95 = 18.1, SPECfp95 = 12.3) Typical power consumption for SBC = 11.0 Watts PowerPC 7410 at 500 MHz The 7410 is Freescale’s long term supported part from its well established and AltiVec enabled G4 family of processors (SPECInt95 = 22.8, SPECfp95 = 17.0) Typical power consumption for SBC = 13.5 Watts System Controller Marvell ‘Discovery’ GT-64260 The Marvell Discovery Integrated System Controller (ISC) combines a high bandwidth memory controller, two PCI interfaces and a range of communications peripherals, all on a single chip L2 Cache 1 MB (with 755) or Dependant on processor choice, either 1 MB or 2 MB of SRAM 2 MB (with 7410) with parity error detection is supported on a 64 bit wide 200 MHz L2 bus Main Memory 64 MB or 128 MB SDRAM The CPU is interfaced to the main memory via a 64 bit data with ECC bus running at 100 MHz. Up to 128 MB SDRAM with ECC can be supported, with 64 MB being fitted as standard FLASH Memory 64 MB FLASH The CPU is interfaced to the FLASH memory via a 32 bit data bus running at 100 MHz. 8 MB are allocated to Boot FLASH and 56 MB to User FLASH Non-volatile RAM 32 Kilobyte (KB) NVRAM NON-VOLATILE RAM combines the advantages of SRAM (fast read and write) and EPROM (non-volatility and in-circuit programmability) providing non-volatile storage for data which must not be lost when power is removed Serial EEPROM 2 KB EEPROM EEPROM is provided on the I2C bus as an optional location for Discovery ISC configuration data Real-Time Clock 1 sec. resolution The RTC provides TOD/calendar with 1 sec resolution. 5V Standby must be connected to maintain data during power down Ethernet Interfaces 10/100 BASE-T 1 or 2 Ethernet Channels are provided from the Discovery 1 or 2 ports ISC and can be accessed through the J2 connector (See Fig. 2 for I/O options) Serial ports RS232/422/485 2 serial channels are provided from the Discovery ISC. Both 2 ports channels are software selectable to be RS232/422 or 485 Async/Sync (See Fig. 2 for I/O options) Discrete Digital I/O 12 bits Up to 12 bits of TTL compatible Discrete Digital I/O are provided from the Discovery ISC, each bit being capable of generating an interrupt. (See Fig. 2 for I/O options) Timers 8 x 32 bit timers Timers are provided from the Discovery ISC Watchdog Timer 1.6 sec time-out The Watchdog timer has a fixed 1.6 second time-out period CompactPCI Interface 32 bit/33 MHz A 32 bit/33 MHz cPCI interface is provided conforming to 3.3 Volts the mechanical definitions of VITA 30.1 DMA controllers 8 available 8 DMA controllers are available in the Discovery ISC for efficiently moving large blocks of data JTAG Interface On-card connector A JTAG header is accessible for both factory test and software de-bug purposes - (IMP1A JTAG-11 Adaptor card required for easy access) Software Support VxWorks provision includes a Board Support Package The ESP includes a software DMA engine, therefore (BSP) designed to strict WindRiver definitions and allowing users to avoid direct and complex hardware supporting all defined features, plus an Enhanced Support programming of this function, plus Synchronous Serial Package (ESP), providing extra hardware-related support support, also BCS (see below). that is not defined by the O/S vendor (therefore possesses Two Deployed Test Software modules are available, Radstone interfaces). The BSP initialization includes a full together providing an overall test philosophy adapted to PCIbus scan, which will configure the Memory and I/O COTS silicon and COTS O/Ss that we believe is unbeaten space of all PCI devices, including any PMC plugged into in the industry. IMP1A, or any further PMCs on IMPCC1 carriers. 2 12 bits GPIO Up to * 32 KB 64 MB Ethernet 2 256 MB FRAM FLASH Ethernet 1 SDRAM Com 2 Com 1 Rear I/O PMC 46 pins Slot Discovery L2 Cache PowerPC Integrated 2 MB for 7410 7410 Systems Controller IIC Bus 32 bit 33 MHz PCI Bus (3.3V) 2 KB RTC EEPROM Figure 1: IMP1A Functional Block Diagram 2 X 10/100 BASE-T Ethernet 12 X Discrete Digital I/O 2 X RS232/422/485 Serial 46 X PMC Rear I/O pins 32 bit, 33 MHz Compact PCI Interface (3.3V) Ethernet 1 Ethernet 2 Serial 1 Serial 2 Discrete Digital I/O Option 1 Yes Yes RS232 RS232/422/485. Async only 12 bits Option 2 Yes No RS232/422/485. Async/Sync RS232/422/485. Async/Sync None Option 3 Yes No RS232 RS232/422/485. Async/Sync 8 bit Figure 2: IMP1A Input/Output Options 3 BIT is supplied as an independent module that runs at initialization, achieving the highest possible coverage by the use of destructive (in system state terms) testing, before passing control to the O/S. In addition to visual failure indication, the application can read BIT results from FLASH. Background Condition Screening (BCS) is supplied as part of the ESP, providing continuous, non-destructive testing for early warning of problems while the application is actually running. BCS runs as a task thread and is specifically designed for co-operation with the VxWorks Operating System. Both Deployed Test Software modules have a broad range of configuration options. Support for the INTEGRITY RTOS on IMP1A is also available direct from our technology partner Green Hills Software Inc. INTEGRITY is a Real-Time O/S providing secure, maximum reliability operation for use in mission-critical embedded systems. The royalty-free INTEGRITY RTOS uses hardware memory protection to isolate and protect itself, and user tasks, from incorrect operation caused by accidental errors or malicious tampering. Without the burden of compatibility with 1980's vintage products, INTEGRITY was designed from the ground up for 32 bit and 64 bit embedded processors, and employs the latest in RTOS technology. Standard Ordering Information Sales Code PowerPact Processor (500 MHz PowerPC 7410) IMP1A-7410-1C100X 500 MHz PowerPC 7410 3U CPCI SBC, Level 1; 128 MB SDRAM, 2 MB L2 Cache, 128 MB FLASH, 2x10/100 BASE-T 1 x RS232, 1 x RS232/422/485 async port, 12 bits GPIO, 1 PMC slot IMP1A-7410-2C100X Air-cooled Level 2 as above with conformal coating USA IMP1A-7410-3C100X Air-cooled Level 3 as above with conformal coating Telephone: +1 (800) 368-2738 IMP1A-7410-4C100X Conduction-cooled Level 4 as above E-mail: sales@radstone.com IMP1A-7410-5C100X Conduction-cooled Level 5 as above EUROPE Telephone: +44 (0) 1327 359444 E-mail: sales@radstone.co.uk X= software option Visit www.radstone.com for a full list of Note: For ordering information, further options and accessories please contact regional offices and contact details your local Radstone sales office © Radstone Technology PLC 2004 Publication RT313 RADSTONE and the Radstone symbol are registered This publication is issued to provide outline information only which (unless agreed by the company in writing) may not be used, trademarks of Radstone Technology PLC. applied or reproduced for any purpose or form part of any order or contract or be regarded as a representation relating to products All other trademarks are the property of their or services concerned. The company reserve the right to alter without notice the specification, design, price or conditions of supply of any product or service. respective owners.