Environmental

Temperature Highest reachable operating temperature depends on processor speed and ambient conditions (airflow) All values under typical conditions w/o PMC module Range Operating Storage Standard 0° C to +70° C –40° C to +85° C Extended –40° C to +85° C –55° C to +85° C Humidity Operating: 5 - 95% @ 40° C Storage: 5 - 95% @ 40° C Altitude Operating: 15,000 ft. (4.5 km) Storage: 40,000 ft. (12 km) Shock (half-sine) C-Style: 12 g/6 ms, 3 axis (up and down, 5 hits/direction) N-Style: 40g /11 ms, 3 axis (up and down, 5 hits/direction) Vibration C-Style: 2 g rms @ 5 to 100 Hz (30 minutes each axis) N-Style: 14 g rms @ 5 to 2000 Hz (30 minutes each axis)

Ethernet

One 10/100 BaseTX Ethernet port to rear I/O (convection- and conduction-cooled) One 10/100 BaseTX Ethernet port to front-panel RJ-45 including Activity and Link LEDs (convection-cooled only) MACs and MII interfaces from MV64460 system controller

Flash Storage

128 MB flash memory Multi-level write-protection

Graphic Processor

Eight programmable GPIO ports Programmable for line direction (input, output), input polarity (inverted, non-inverted), output type (TTL, open-drain), and interrupt masking Independent interrupt for each port

Mechanical

PICMG 2.0 R3.0 and VITA 30.1 compliant 6U, 1 slot wide 233 x 160 x 20 mm

MTBF

Calculations are available in accordance with MIL-HDBK-217.

Networking

ST M48T37V device 32 KB non-volatile RAM RTC 146818 compatible, on-board Li-battery

PCI

PCI2050B PCI/PCI bridge Provides 32-bit 33 MHz PCI bus for USB controller Provides isolation for 66 MHz PCI bus 1 from 33 MHz USB controller

PCI bus

Two PCI bus interfaces from MV64460 system controller PCI bus 0: 32/64-bit 33/66 MHz (dedicated to PMC0 site) PCI bus 1: 32/64-bit 33/66 MHz, VIO selectable (+5V/+3.3V) through header/jumper site (shares PMC1 site, USB controller through PCI2050B PCI bridge, and PCI 6254 PCI bridge)

PMC #1

Compliant to VITA 30.1-2001 and ANSI/VITA 20-2001 PMC0 site on dedicated PCI bus 0 (supports standard PCI configurations) PMC1 site on shared PCI bus 1 (supports standard PCI configurations) Both PMC sites support rear I/O

Power Connector

+5 V, +3.3 V, ±12 V Total power max. 7.5 W

Power Requirements

+5 V, +3.3V required ±12V only if required by mounted PMC module

Processor

Motorola PowerPC MPC7447A G4 processor Core processor speeds: up to 1 GHz High performance, low power, 32-bit PowerPC RISC architecture Superscaler processor 32 KB L1 instruction and data caches 512 KB L2 on-chip cache 64-bit 167 MPX system bus interface to MV64460 system controller

Safety Criteria

Designed to meet standard UL1950/60950 Designed to meet FCC Part 15, SubPart A

SDRAM

Soldered DDR333 SDRAM SDRAM controller from MV64460 system controller 64-bit (72-bit with ECC) 167 MHz memory bus Capacities: 512 MB standard (256 MB and 1 GB offered as build options)

Serial

Two RS-232 serial ports: COM1, COM2 on cPCI_J5 Two Multi-Protocol Serial Controllers (MPSC) from the MV64460 system controller Independent RS-232 differential receiver and line drivers Four RS-422 serial ports: COM3–COM6 on cPCI_J4 ST16C654 Quad UART on 32-bit Device bus Independent Quad RS-422 receiver and line driver

Technology

CPU die and ambient temperature Software readable from –55° C to +125° C

USB

Two USB 2.0 ports to cPCI_J4 Three speeds supported: USB 1.0 (1.5 MHz), USB 1.1 (12 MHz), and USB 2.0 (480 MHz)

Watchdog Timer

ST M48T37V NVRAM/RTC MV64460 system controller Software selectable