Environmental

Temperature Operating Storage C-style * 0°C to +70°C –40°C to +85°C N-style ** –40°C to +85°C –55°C to +105°C * Minimum airflow of 200 LFM required ** Measured at card edge. Humidity (non-condensing) Operating: 5–95% @ 40°C Storage: 5–95% @ 40°C Altitude Operating: 4.5 km (15,000 ft.) Storage: 12 km (40,000 ft.) Shock C-style 20g/11ms, 3 axes, up & down, 3 hits/direction N-style 40g/11ms, 3 axes, up & down, 3 hits/direction 100g/6ms, 3 axes, up & down, 3 hits/direction Vibration C-style 0.04g2/Hz @ 5–100Hz (2g rms), 60 min./axis N-style 0.1g2/Hz @ 5–2000Hz (12g rms), 60min./axis

Ethernet

Three 10/100/1000BaseT Ethernet port to rear I/O MACs provided by the MV64460 system controller Independent quad port PHY

Flash Storage

128 flash memory Multi-level write-protection

Graphic Processor

16 programmable GPIO ports Programmable for line direction (input, output), input polarity (inverted, non-inverted), output type (TTL, open-drain), interrupt type (edge, level sensitive) and interrupt masking +5V tolerant Independent interrupts for each port

Mechanical

PICMG 2.0 R3.0 and VITA 30.1 compliant 6U, 1 slot wide 233 mm x 160 mm x 20 mm Weight C-style: TBD N-style: TBD

MTBF

Calculations are available in accordance with MIL-HDBK-217.

PCI bus

Two PCI bus interfaces from MV64460 system controller PCI bus 0: 32/64-bit 33/66 MHz PCI/133 MHz PCI-X (dedicated to PMC0 site) PCI bus 1: 32/64-bit 33/66 MHz (shared by PMC1 site, USB controller, and PCI 6254 PCI bridge) Both PCI buses configurable VIO (+3.3V or +5V through on-board jumpers)

PMC #1

Two VITA 30.1-2001 and ANSI/VITA 20-2001-compliant PMC sites PMC0: 64-bit 33/66MHz PCI or 133MHz PCI-X PMC site on dedicated PCI bus 0 PMC1: 64-bit 33/66MHz PCI PMC site on shared PCI bus 1 Both PMC sites provide 64-bit user I/O (rear I/O) Both PMC sites (PCI busses) VIO configurable to +3.3V or +5V through on-board jumper

Power Connector

+5V, +3.3V, ±12V: Total power max. 7.5W per site

Power Requirements

+5V, +3.3V—required +12V required, -12V optional Battery backup for RTC (+3.3 on BATT+)

Processor

Motorola MPC7447A PowerPC G4 processor Core processor speeds up to 1 GHz High performance, low power, 32-bit PowerPC RISC architecture Superscalar processor 32 KB L1 instruction and data caches 512 KB L2 on-chip cache 64-bit 167 MHz MPX system bus interface to MV64460 system controller

RTC

Real-time clock feature for timekeeping functions Battery backup maintained through off-board +3.3V supply (provided by system through backplane (BATT+) pin at cPCI_J5)

Safety Criteria

Designed to meet standard UL1950/60950 Designed to meet FCC Part15, SubPart A

SATA

PCI-to-serial ATA host controller on PCI bus 1 Two 1.5 Gbps SATA 1.0 ports to backplane

SDRAM

Soldered DDR333 SDRAM SDRAM controller from MV64460 system controller 64-bit (72-bit with ECC) 167 MHz memory bus Capacities: 512 MB, or 1 GB

Serial

Two serial ports from multi-protocol serial controller (MPSC) integrated in the MV64460 system controller —COM1, COM2 Two serial ports from USARTs integrated in the FPGA—COM3, COM4 COM1, COM2: Two independent serial ports configurable as asynchronous RS-232 or synchronous/asynchronous RS-422 available at cPCI_J5 COM3, COM4: Two independent serial ports configurable as asynchronous RS-232 or synchronous/asynchronous RS-422 available at cPCI_J4 Software selectable Four independently configurable synchronous/asynchronous RS-422/485 serial ports: COM5–COM8 available at cPCI_4 USART integrated into FPGA

Technology

CPU die and ambient temperature Software readable from –55°C to +125°C

USB

Four USB 2.0 ports: three (USB1–USB3) to cPCI_J5 (all configurations) and one (USB4) to the front panel (C-style version only) Three speeds supported: USB1.0 (1.5 MHz), USB1.1 (12 MHz), and USB2.0 (480 MHz)

Watchdog Timer

MV64460 system controller Programmable intervals Interrupt and board reset triggers