GLC65 Commercial/GLM65 Medical 65 Watt Multiple Output Global Performance Switchers FEATURES: 65 Watt Wide Range Input High Efficiency (Up to 90%) Universal input 90-264 Vac 2-year warranty Also available in single outputs Conducted EMI exceeds FCC Class B and CISPR 22 Class B (Commercial models) and CISPR 11 Class B (Medical models) Exempt from line harmonics standard EN61000-3-2 Commercial Approved to UL1950, CSA-C22.2 No. 950, EN60950 • Medical Approved to UL2601-1, CSA 22.2 No. 601.1, and EN60601-1 marked to LVD SPECIFICATIONS: Ac Input 90-264 Vac, 47-63 Hz single phase Minimum Load Output Power No minimum load required on any output. However, Total continuous output power is 60 W, 75 W peak for 60 s regulation limits may be exceeded if extreme conditions 10% duty cycle. Total continuous rating with 150 LFM of are applied. Contact factory for assistance. air is 70 W. Temperature Coefficient: 0.03%°C typical on all outputs. Input Current Units are exempt from input current harmonic require- Voltage Adjustment ments of EN61000-3-2 when output power is less than Units provided with potentiometer capable of a minimum 62W. Maximum input current at minimum input voltage adjustment range of +/- 5% from nominal setting. and output overload will be less than 2.0 A. EMI / EMC Compliance: Inrush Current All models include built-in EMI filtering to meet the EMC Inrush is limited by internal thermistor. The inrush at 240 requirements of IEC601-1-2. Vac, averaged over the first ac half-cycle under cold start Performance EMC Standard conditions will not exceed 37 A. Conducted Emissions GLC65 EN55022, Class B; FCC Class B Conducted Emissions GLM65 EN55011, Class B; FCC Class B Input Protection Static Discharge EN61000-4-2, Level 3 Internal AC fuse provided on all units. Designed to blow RF Field Susceptibility EN61000-4-3, Level 3 only if a catastrophic failure occurs in the unit -- Fuse Fast Transients / Bursts EN61000-4-4, Level 3 does not blow on short circuit or unsustained overload. Surge Susceptibility EN61000-4-5, Level 3 Conducted RF Susceptibility EN61000-4-6, 3V, 80% Holdup Time Voltage Sags & Surges EN61000-4-11 Output voltage stays within regulation for 20 ms from loss Line Frequency Harmonics EN61000-3-2 Class A (>62Wout) of ac input at 65 W load, from 120 Vac input. Exempt (<62Wout) GLC65 Commercial - Safety Efficiency Condor DC Power Supplies, Inc. declares under our sole 80% typical. responsibility that all models are in conformity with the applicable requirements of EN60950 following the Overload Protection provisions of the Low Voltage Directive 73/23/EEC. All Fully protected against short circuit and output overload. models are approved to UL1950 (with no D3 deviations), Short circuit protection is cycling type power limit and will CSA22.2 No. 950-95 3rd edition, Level 3, IEC950, automatically recover after removal of fault. EN60950. CB certificate available. Overvoltage Protection Commercial Leakage Current Built in with firing point set. OVP firing reduces output to Less then 500 µA @ 120 Vac. Less then 1.2 mA @ 240 Vac. less than 50% of nominal voltage in less than 50 ms. GLM65 Medical - Safety Output Noise Approvals: All models are certified to be in compliance 0.5% rms, 1% pk-pk, 20 MHz Bandwidth, differential with the applicable requirements of UL2601-1, CSA 22.2 mode. Measured with scope probe directly across output No. 601.1, IEC 601-1 (1988), EN 60601-1: 1990. terminals of the power supply with load terminated with 1µF capacitor. Medical Leakage Current 40 µA under normal conditions (132 Vac @ 60 Hz). Transient Response Maximum under single fault conditions (264 Vac @ 60 Main Output - 500 µs typical response time for return to Hz) is 170 µA. within 0.5% of final value for a 50% load step within the regulation limits of minimum and maximum load, Δi/Δt< 0.2 A/µs. Maximum voltage deviation is 3.5%. Condor D.C. Power Supplies, Inc., 2311 Statham Parkway, Oxnard, CA 93033 800-235-5929 • 805-486-4565  FAX 805-487-8911  www.condorpower.com 38 GLC65 Commercial/GLM65 Medical 65 Watt Multipe Output Output Commercial Medical Output Total V1 Adjustment OVP Ripple/ Output No. Output Maximum Model Model Maximum (A) Regulation (E) Note (C) Setpoint Noise (B) GLC65A GLM65A 1V+A 5.0 7A9% 2 6± .20% .6V 1 ±% 5 2V+A 12 3A5%5----% 1 3V-A 12 2A .5 4%6----% 1 GLC65B GLM65B 1V+A 5.1 7A9% 2 6± .20% .6V 1 ±% 5 2V+A 15 2A .5 4%4----% 1 3V-A 15 2A3%5----% 1 GLC65D GLD65D 1V+A 5.0 7A9% 2 6± .20% .6V 1 ±% 5 2V+A 24 1A .5 2% .5 3----% 1 3V-A 12 2A .5 4%6----% 1 GLC65E GLM65E 1V+A 5.0 7A9% 2 6± .20% .6V 1 ±% 5 2V+A 24 1A .5 2% .5 3----% 1 3V+A 12 2A .5 4%6----% 1 GLC65G GLM65G 1V+A 5.0 5A8% 3 ±% 5 6± .20% .6V 1 2V+A 3.3 4A5%3----% 1 3V+A 12 2A .5 4%6----% 1 GLC65H GLM65H 1V+A 3.3 5A8% 3.5 4±V .3.% 8 1 ±% 5 2V+A 5.0 4A6%4- .5 ---% 1 3V+A 12 2A .5 3%6----% 1 Notes: A. Continuous individual output ratings for unrestricted convection cooling. Combination of individual output loads must not exceed total power rating. B. Peak rating for 60 s 10% duty cycle or continuous rating 150 LFM forced air cooling. C. Adjustment on V1 varies all outputs simultaneously (1% on V1 @ 1% on V2 & V3). D. Total combined current of V1 & V2 not to exceed 12 A. Combination of individual output loads must not exceed total power rating. E. Total regulation is defined as maximum deviation from the initial set point. With all other outputs at 50% load, output under test can be varied from 0 to 100% load and varied to any ac line voltage. Initial set point is 1% on V1, 2% on V2 and 3% on V3 GLC65/GLM65 MECHANICAL SPECIFICATIONS J1 INPUT: AMP P/N 640445-3, .156 [3.96mm] CTR, .045 [1.14mm] Square pin header PIN 3) Ac Neutral PIN 2) No Pin PIN 1) Ac Line J2 OUTPUT: AMP P/N 640445-6, .156 [3.96MM] CTR .045 [1.14MM] Square pin header PIN 1) Output #2 PIN 2) Output #1 PIN 3) Output #1 PIN 4) Common PIN 5) Common PIN 6) Output #3 GROUND: .250 X 0.32 Faston Tab MATING CONNECTORS: AMP P/N AMP HOUSING CONTACTS INPUT 640250-3 770476-1 OUTPUT 640250-6 770476-1 WEIGHT: 6.5 OZ. [.182 KG] OPTIONAL CHASSIS/COVER KIT: P/N 08-30466-0065 NOTE: 5 A Maximum recommended current per connector pin convection, 7A with air. A. Units should be allowed to warm up/operate under non-condensing conditions Environmental Operating Non-operating before application of power. Derate output current and total output power by 2.5% Specification per °C above 50°C. Derate output power and current on all outputs by 2.5 % per °C o o T0 emperature (A) 0 to 5C5 -40 to +8 C For operation in a confined space, moving air may be required. Under all conditions, the cooling vs. load profile should be such that heat sinks and/or HH umidity (A)0H to 95% R 0 to 95% R heatsink temperatures do not exceed 90 °C for extended periods. Sg hock (B) 20 40 g B. Random vibration—10 to 2000Hz, 6dB/octave roll-off from 350 to 2000Hz, 3 pk pk orthogonal axes. Tested for 10 min./axis operating and 1 hr./axis non-operating. At ltitude-t 500 to 10,000 f -500 to 40,000 f C. Shock testing—half-sinusoidal, 10 ± 3 ms duration, ± direction, 3 orthogonal axes, 2 2 total 6 shocks. Vg ibration (C) 1.5 , 0.003 g/g Hz 5 , 0.026 g /Hz rms rms Condor D.C. Power Supplies, Inc., 2311 Statham Parkway, Oxnard, CA 93033 800-235-5929  805-486-4565  FAX 805-487-8911  www.condorpower.com 39