NetVanta Dual T1/FT1 Network Interface Module (NIM) P/N 1202872L1 INSTALLATION INSTRUCTIONS WAN T1/1 WAN T1/2 DBU 1. Remove power from the base unit. 2. Remove the cover plate from the option slot. 3. Slide the option module into the option slot until the module is firmly seated against the chassis. 4. Secure the pins at both edges of the module. SPECIFICATIONS 5. Connect the cables to the associated device(s). AOS Version Requires AOS 17.8 or later 6. Complete the installation of the base unit. Operating Frame Relay, Multilink Frame Relay, PPP, Multilink PPP, 7. Restore power to the base unit. Modes HDLC T1/FT1 Supported Standards: AT&T TR 62411, AT&T TR 54016, For NetVanta modules with outside plant Interfaces Bellcore TR 194, ANSI T1.403 connections, ensure that all cables are Line Rate: 1.544 Mbps ±75 bps removed from the module before installing Line Code: AMI or B8ZS or removing it from the NetVanta chassis. Framing: D4 (SF) or ESF FT1 Line Rate: DS0 channelized (multiples of 64 kbps) Input Signal: 0 to -36 dB (DS1) WAN T1/1 AND T1/2 NETWORK CONNECTION PINOUTS Line Build-Out: 0, -7.5, -15, -22.5 dB (long), 0 to 655 ft (short) Pin Name Description Connector: RJ-48C DS0 Assignment: Programmable 1 R1 Receive data from the network - Ring 1 Clock Source Network, internal 2 T1 Receive data from the network - Tip 1 15 Diagnostics Test Pattern Generation and Detection: QRSS, 511, 2 - 1, 3 — Unused 20 2 - 1, all ones, all zeros Network loopbacks (local and remote); responds to both 4 R Transmit data toward the network - Ring inband and FDL loop codes 5 T Transmit data toward the network - Tip Alarm generation and detection Network and user sets of performance data (15 minutes and 6-8 — Unused 24 hours) Compliance FCC Part 15 Class A, EN 55022 Class A, EN 55024 An optional analog modem dial backup interface ACTA/TIA-968/FCC Part 68 module (DIM) is required for dial backup UL/CUL 60950-1 applications. For a description of the DBU pinouts, refer to the quick start guide included with your Physical Dimensions: 2.75-inch W x 4.25-inch D Operating Temperature: 0°C to 50°C DIM shipment. Storage Temperature: -20°C to 70°C Relative Humidity: Up to 95 percent, noncondensing Important: For additional details on product features, specifications, installation, and safety, refer to the appropriate hardware installation guide NetVanta modules should be installed only in NetVanta available on ADTRAN’s Knowledge Base at Series products. http://kb.adtran.com. Quick Start Guide, 61202872L1-13C, August 2011 Copyright © 2011 ADTRAN, Inc. All Rights Reserved.