GSM15 Medical 15 Watt Global Performance Medical Switcher FEATURES: Small, miniature 15 watt, single output Models available in 5, 12, 15, 24, 28 Vdc outputs Power Density of over 3 watts per cubic inch Small package 3.00 x 2.10 x .85 inches Medical approvals to UL2601-1, IEC60601-1, CSA-C22.2 No. 601-1, EN60601-1 Exceeds FCC and CISPR11 Class B conducted emissions requirements marked to LVD SPECIFICATIONS: Ac Input Temperature Coefficient 90-264 Vac, 47-63 Hz single phase. Class 1 or class 2 0.03% / °C typical. grounding. EMI/EM Compliance Input Current All models include built-in EMI filtering to meet the EMC Maximum input current at 90 Vac, 60 Hz with full rated requirements of IEC601-1-2. output load not to exceed 0.6 A. Pd erformance RequirementEn MC Standar Typical Margi Input Protection CB onducted EmissionsEd N55011, Class B; FCC Class 2 dB Class II Gn 6 dB Class I Gnd Internal ac fuse provided on all units. Designed to blow S3 tatic DischargeEV N61000-4-2, Level 2 k only if a catastrophic failure occurs in the unit -- Fuse R3 F Field SusceptibilityEV N61000-4-3, Level 2 does not blow on unsustained overload or short circuit. F3 ast Transients/BurstsEV N61000-4-4, Level 500 S3 urge SusceptibilityEV N61000-4-5, Level 500 Inrush Current Cy onducted RF Su6 sceptibilitE% N61000-4- 25 Inrush is limited by internal thermistors. The inrush at 240 V1 oltage Sags & SurgesE% N61000-4-1 5 Vac, averaged over the first ac half-cycle under cold start conditions will not exceed 37 A. Medical Safety Approvals Efficiency All models are Certified to be in compliance with the 69-85% depending on model. applicable requirements of UL2601-1, IEC60601-1, CSA-C22.2 No. 601-1, EN60601-1. Overload Protection Fully protected against short circuit and output overload. Leakage Current Short circuit protection is cycling type power limit. Factory The maximum leakage current for GSM15 series will be set to begin power limiting at 23 W. as follows; Overvoltage Protection 132Vac/60Hz UL2601-1 test method Built in OVP on all models. Approximately 120-140% of GND Connection Normal Single Fault output voltage. Class I 75 µA 105 µA Class II 39 µA 54 µA Output Noise 0.5% rms, 1% Pk-Pk, 20 MHz Bandwidth, differential 264Vac/50Hz IEC60601-1 test method mode. Measured with noise probe directly across output GND Connection Normal Single Fault terminals of the power supply. Class I 128 µA 180 µA Class II 66 µA 94 µA Transient Response Main Output - 500 ms max. response time for return to within 0.5% of final value for a 50% load step change, Δi/ Δt< 0.2 Aµs. Maximum voltage deviation is 3.5%. Condor D.C. Power Supplies, Inc., 2311 Statham Parkway, Oxnard, CA 93033 800-235-5929 • 805-486-4565  FAX 805-487-8911  www.condorpower.com 16 GSM15 Medical 15 Watt Single Output Medical Voltage Total Model Output Min. Normal (A) Peak (B) Noise P-P OVP Setpoint Regulation Ripple and Noise GSM15-5 5A .1 V0A2A .35 3%2V .5 7% .2 2% 1 GSM15-12 1A 2 V0A1A .25 1% .5 2V .5 1% 6 2% 1 GSM15-15 1A 5 V 0A1A .0 1% .2 2V .5 2% 1 2% 1 GSM15-24 2A 4 V0A0A .625 0% .75 2V .5 3% 2 2% 1 GSM15-28 2A 8 V0A0A .54 0% .64 2V .5 2% 80 2% 1 Notes: A. Rating with unrestricted convection cooling. B. Peak Power for 60 sec. 10% duty cycle or continuous rating with 150 LFM of airflow. GSM15 MECHANICAL SPECIFICATIONS: INPUT: J1 AMP P/N 640456-4 PIN 1) AC LINE PIN 2) N/C PIN 3) N/C PIN 4) AC NEUTRAL GND: 0.098 DIA. THRU HOLE OUTPUT: J2 AMP P/N 640456-4 PIN 1) COMMON Return PIN 2) COMMON Return PIN 3) OUTPUT #1 + Vout PIN 4) OUTPUT#1 +Vout MATING CONNECTOR AMP P/N MTA – 100 Recepticle NOTE: 3A MAXIMUM RECOMMENDED CURRENT PER CONNECTOR PIN Overall Dimensions: 2.65 x 2.10 x .85 inches 67.31mm x 53.34mm x 21.59mm Weight: 0.25 LBS. [.113 kg] MAX. Environmental Operating Non-operating Specification o o T0 emperature (A) 0 TO 5C5 -40 to +8 C HH umidity (A)0H to 95% R 0 to 95% R A. Units should be allowed to warm up/operate under non-condensing conditions before application of power. Sg hock (B) 20 40 g pk pk B. Random vibration—10 to 2000Hz, 6dB/octave roll-off from 350 to 2000Hz, 3 At ltitude-t 500 to 10,000 f -500 to 40,000 f orthogonal axes. Tested for 10 min./axis operating and 1 hr./axis non-operating. C. Shock testing—half-sinusoidal, 10 ± 3 ms duration, ± direction, 3 orthogonal 2 2 Vg ibration (C) 1.5 , 0.003 g/g Hz 5 , 0.026 g /Hz axes, total 6 shocks. rms rms Condor D.C. Power Supplies, Inc., 2311 Statham Parkway, Oxnard, CA 93033 800-235-5929  805-486-4565  FAX 805-487-8911  www.condorpower.com 17