Portwell PPAP-250 Specification PPAP-250 Communication Appliance Board Specification # Item Specification Memory Support 1 1 x 168-pin DIMM socket supports PC100/133 MHz and up to 512 SDRAM, NO ECC Chipset 2 Intel 815E/ B-stepping ® Processor 3 The M/B board supports uni-processor implementation for Intel Celeron™ up to PIII processor and Tualatin™ (0.13um PIII) 1.26GHz. ® 4 on board 10/100 1x internal Intel 82562ET 4 ® Fast Ethernet port 3x Intel 82559er On-board 5 0. Two build-in type LEDs on RJ-45 sockets. LAN-ports LED 1. Left: ACT/LNK, green. Off - no connection. On - good linkage. Flashing - data accessing 2. Right: 10/100, yellow. Off - data transfer rate at 10Mbps. On - data transfer rate at 100Mbps. The LED works only when the left one (for ACT/LNK) is on. Otherwise it should be off. 6 PCI Expansion A Golden finger is designed for connecting to a Back Plane that consists of two PCI slots (ABP-03V2F) or one PCI and one PICMG slots (PBP-02V2A). The PCI Connecter fully compliant with PCI 2.1 spec with DC +/- 12V, 5v, and 3.3v. 5.75” (146mm) W x 9.5” (241mm) L Motherboard size 7 The board conforms with the 5.75” x 8.5” mounting holes. 8 Thermal diodes The thermal diodes on the processor is supported for temperature read out On Processor via suitable application software and/or BIOS code Power supply 9 ð AT type PSU. ð 100~127VAC and 200~240VAC switch selectable input. ð 50~60 Hz line frequency ð Max. output: 100W. 10 USBs One USB channels with pin connector for dual USB ports. IDE channels 11 Two IDE channels, one 40-pin and one 44-pin. The 44-pin IDE connector (2mm pitch) supports PNA-CFB card (Compact flash adaptor board) LEDS connectors 12 8 user programming LED board driven from GPIO pins on the front of the M/B via Pin connectors. VGA 13 An integrated VGA pin connector for holding the VGA adapter card (PNA-V100). EIA/TIA232 14 2 COM ports on Board, one is 2x5 pin connector and the other is DB9 for system console MiniPCI interface 16 A MniPCI pin socket (Type IIIA) supports MiniPCI module. ie. modem Watch Dog Timer 17 The WDT supports 255 intervals from 0.5 sec/ Min to 254.5 sec/ Max by s/w programming. WDT time-out will issue H/W reset signal to reset the system Page 1 of 2 Portwell PPAP-250 Specification # Item Specification 18 System Monitoring CPU & System Temperature, FAN RPM, and operating voltage +8 +0.20 19 PCB-thickness It shall follow PICMG norm: T= 62 mil (1.57 mm) -5 -0.13 Reset button RS232 for USB pin-connector System Console COM-2 4x 10/100 FastEthernet Ports 40pin IDE interface 44pin IDE interface Mini PCI interface Golden Finger for expansion DIMM socket through PICMG 3x 3pin connectors for CPU & system fans Power input connector Page 2 of 2