CN2510/2610 Async Server CN2610 Series 8/16 Port Dual LAN RS-232 Async Server Features • Support LCM interface for easy to on-site management • Support 2 IP Address and 2 MAC Address • Dual-host Redundant Data Acquisition Solution (DRDAS) • DRDAS provide two priority level by 1 Primary and 3 Secondary connection • Real COM/TTY dirver for Windows and Linux • Console Management for Router, PBX, Server • ASPP or Standard BSD for Socket Programming • Remote management via telnet, SNMP II Designed for mission critical applications More and more industrial applications are facing the challenge be realized from different LAN/WAN networks. CN2610 can to integrate serial devices, like RTUs, into a reliable LAN network. provide access and management of any combination of serial CN2610 series is special designed with dual LAN, dual MAC, devices: RTU, Server, Routers, Workstations, LAN/WAN devices dual IP addresses to answer the highly redundant LAN network and more. CN2610’s dual-host redundant solution can send/ requirements. With dual LAN design, redundant access can receive serial data to 4 IP addresses on the network. Application: Dual-host Redundant Data Acquisition Solution (DRDAS) e-mail:info@moxa.com.tw www.moxa.com CN2610 Series CN2610 Series Total Solution for Industrial Device Networking Dual Host, Dual LAN, Dual CN2610 build up a redundant system In order to prevent "Single point failure", most of the Host redundant: CN2610 can provide the synchronous redundant systems provide different level of "Redundant" communication ability to establish connections to Primary PC and solutions. These redundant solutions not only need hardware Backup PC at the same time. Once Primary PC is dead backup PC physical redundant mechanisms via some "watch dog" will take over the control immediately. hardware but also need software to build up a "Token" switching mechanism. CN2610 provides a Dual-host Primary PC and LAN B dead Redundant Data Acquisition Solution (DRDAS), which is suitable for highly redundant data acquisition requirments. Following description is an introduction of CN2610’s DRDAS solution. LAN redundant: CN2610 provide 2 LAN port to connect to different LAN network. Via using routing table, CN2610 supports full communication ability to send packets into different network. From different LAN network, host also Data acquisition redundant: CN2610 DRDAS mode plays can connect to CN2610 via different IP address. If LAN A is the role to communicate with up to 4 IP addresses. In the previous crash or dead, PC with dual network interface cards still can page’s picture, CN2610 receive the RTU’s data from serial port, communicate with CN2610 via LAN B. and send the data to 4 IP addresses in 2 PC in the different LAN. 1 of the 4 IP address is the primary IP to send the down stream data to RTU and the other 3 IP cannot send data to RTU. Via this Primary PC and LAN A dead architecture, if Primary PC, LAN B and Primary CN2610 crash at the same time, the system still work without problem. Primary PC, LAN B, and 1st CN2610 dead CN2610 Appearance LCM Display Panel LED Indicators Rest Button System status, Serial Tx/Rx Push Buttons Ethernet RJ45 10/100 Mbps Serial Ports RS-232 console Port RJ45 (8-pin), RS-232, 50 to 230.4 Kbps AC Power Input 100-240 VAC input, 47-63 HZ Connection Cable 19-inch Rackmount RJ45 8-pin to DB9 Cable The Rackmount Kit is a Standard accessory e-mail:info@moxa.com.tw www.moxa.com CN2510/2610 Async Server Dimensions Optional Accessories RJ45 to DB-type cables CBL-RJ45M25-150 CBL-RJ45M9-150 8-pin RJ45 to Male DB25, 150 cm 8-pin RJ45 to Male DB9, 150 cm CBL-RJ45F9-150 CBL-RJ45F25-150 8-pin RJ45 to Female DB9,150 cm 8-pin RJ45 to Female DB25,150 cm RJ45 RS-232 port pin asignment PIN RS-232 PIN RS-232 1 DSR (in) 5 RxD (in) 2 RTS (out) 6 DCD (in) 1 8 3 GND 7 CTS (in) 4 TxD (out) 8 DTR (out) e-mail:info@moxa.com.tw www.moxa.com CN2610 Series CN2610 Series Total Solution for Industrial Device Networking Specifications Programming Hardware Real COM/TTY Driver: Windows 9x/NT/ME/2K/XP/2003, Kernel Linux (kernel 2.2.x , 2.4.x) CPU: 32 bit RISC Fixed TTY Driver: SCO OpenServer 5 , SCO Unixware 7.x, RAM: 4 MB Linux (kernel 2.2.x , 2.4.x) Flash ROM: 512 KB Moxa ASPP: Windows 9x/NT/ME/2K/XP/2003, Linux, I/O controller: 16C550C Compatible UART all UNIX based on socket support Interface Socket: Standard BSD Socket interface LAN: RJ45 8-pin connector No. of ports: 2 Speed: 10/100 Mbps Applications Protection: 1.5 KV magnetic isolation Terminal Sessions: 8 sessions per port Serial Port: RJ45 (8-pin) connector Interface type: RS-232 Environment No. of ports: 16 ports (CN2610-16), 8 ports (CN2610-8) Power Requirments Speed: 50 to 230.4 Kbps Power Input: 100 to 240V, 47 to 63 Hz Signals: TxD, RxD, RTS, CTS, DTR, DSR, DCD, GND Power Consumption: Protection: 15 KV ESD for all signals 235 mA for 100V, 145 mA for 240V Console Port: 1 RS-232 console port (RJ45, 8-pin) Environment Operating Temperature: 0 to 55°C (32 to 131°F) Software Operating Humidity: 5 to 95% RH Protocols: TCP/IP, UDP, ICMP, NetBUEI, DHCP, PPP, SLIP, Storage Temperature: CSLIP -20 to 75°C (-4 to 167°F) Applications: Telnet, rlogin, rtelnet, DNS, LPD, RCP, WINS, Dimensions Dial-on-Demand Dimensions: 440 x 198 x 45 mm (17.3 x 7.8 x 1.77 in) Security: RADIUS, Dialback, PAP, CHAP, Local user / password Regulatory Approvals Management: SNMP MIB-II EMC: FCC Class A, CE Class A IP routing: Static, RIP-I, RIP-II. Safety: UL, CUL, TÜV Ordering Information CN2610-8 8-port RS-232 dual LAN Async Server, 100 to 240 VAC power input CN2610-16 16-port RS-232 dual LAN Async Server, 100 to 240 VAC power input All items include: CN2610 Quick installation Guide, Document and software CD-ROM, Power Cord x 1, CBL-RJ45F9-150 x 1, CBL-RJ45M25-150 x 1 Optional Cables CBL-RJ45M9-150: RJ45 8-pin to DB9 Male cable, 150 cm CBL-RJ45F9-150: RJ45 8-pin to DB9 Female cable, 150 cm CBL-RJ45M25-150: RJ45 8-pin to DB25 Male cable, 150 cm CBL-RJ45F25-150: RJ45 8-pin to DB25 Female cable, 150 cm e-mail:info@moxa.com.tw www.moxa.com