Datasheet MVME162PA2 VME Embedded Controller with Two IndustryPack Slots Dual IndustryPack logic interface for embedded monitoring and control applications The MVME162PA2 embedded controller provides a powerful and functional processor that can be customer-configured for specific applications. With the compute power of the MC68040 and the flexibility of the IndustryPack mezzanine interface, the MVME162PA2 combines the mechanical ruggedness of VME with the cost effectiveness of PC-type products. The inclusion of the Petra application-specific integrated circuit (ASIC), which replaces functions formerly implemented in the IP2 chip and MC2 chip, improves the performance of the memory subsystem. Memory configuration switches enable the customer to tailor memory size for applications requiring smaller memory configurations. ■25 MHz MC68040 with floating-point coprocessor Ethernet SCSI RJ-45 RJ-45 RJ-45 RJ-45 Front Panel ■High-performance DMA, supports VMEbus D64 and local bus memory burst cycles IP A IP B Serial I/O ■32MB of configurable SDRAM with ECC option Controllers Flash 85230■128KB of SRAM with battery backup 1MB ECC SDRAM 32MB Petra ASIC ■1MB of Flash memory Configurable NVRAM EEPROM■8K x 8 NVRAM and time-of-day clock with battery RTC 2MB backup MK48T58 ■Four serial communication ports, configured as EIA-232-D DTE (routed to front panel and P2) ■Two 16-bit or one 32-bit IndustryPack ports with one VMEbus Ethernet SCSI SRAM 128KB Interface Controller Coprocessor MC68040 DMA channel per port Battery-backed VMEchip2 i82596CA 53C710 ■Six 32-bit timers, one watchdog timer ■One SCSI interface ■One Ethernet interface P2 ■Two 32-pin JEDEC DIP sockets for EPROM VMEbus A16-32, D08-64, BLT, UAT, MBLT ■Remote Reset/Abort/Status control functions Master/Slave ■On-board debugger and diagnostic firmware SNAPHAT Battery MVME162PA2 Details MVME16 2PA2 DETAILS IndustryPack Interface Peripheral Interface A key feature of the MVME162PA2 is the IndustryPack Peripheral I/O connections for the MVME162PA2 are interface. IndustryPack modules provide a wide variety located on the front panel of the module. The serial port of connectivity to “real-world” I/O. Expansion is connection is via four RJ-45 connectors. The SCSI device accomplished by means of a mezzanine board mounted is interfaced via an industry-standard 68-pin connector. to the MVME162PA2. Up to two single-wide A DB-15 connector is used for the Ethernet connection. IndustryPack modules can be installed on the IndustryPack I/O signals are available via 50-pin MVME162PA2 and still occupy only one VME slot. connectors behind the front panel for connecting external I/O devices. VMEbus Interface VMEbus interface functionality is provided by the Memory Options VMEchip2 ASIC designed by Motorola. In addition to The MVME162PA2 provides users with a number of data controlling the system’s VMEbus functions, the storage options such as SDRAM with ECC option, VMEchip2 includes a local bus to/from the VMEbus EPROM/ROM, Flash, and battery-backed SRAM. DMA controller, VME board support features, as well as Software Support a global control and status register (GCSR) for The MVME162PA2 is supported by a wide range of real- interprocessor communications. The MVME162PA2 also time kernels and embedded operating systems. provides support for the VME D64 specification within the VMEbus interface, further enhancing system LynuxWorks, Inc.: LynxOS performance. Integrated Systems, Inc.: pSOS+ Microware Systems Corporation: OS-9 Microtec: VRTX32 Wind River Systems, Inc.: VxWorks Sp ec ific atio ns SPECIFICATIONS Processor Memory Microprocessor: MC68040 Synchronous Dynamic RAM Clock Frequency: 25 MHz Capacity: 32MB Read Burst Mode: 4-1-1-1 VMEbus ANSI/VITA 1-1994 VME64 (IEEE STD 1014) Write Burst Mode: 3-1-1-1 Shared: VMEbus and local bus DTB Master: A16–A32; D08–D64, BLT, UAT + MBLT Static RAM DTB Slave: A16–A32; D08–D64, BLT, UAT + MBLT Capacity: 128KB Arbiter: RR/PRI Read Burst Mode: 5-3-3-3 Interrupt Handler: IRQ 1–7 Write Burst Mode: 5-3-3-3 Interrupt Generator: Any 1 of 7 Parity: No System Controller: Yes, jumperable Shared: VMEbus and local bus Location Monitor: Four, LMA32 Battery Type: Lithium IndustryPack Logic Interface Battery Life 406 days continuous backup at 25° C, (approximate): 81 days at 70° C Data Width: 16/32-bit ROM/EPROM (150ns) Interrupts: Two levels Number of Sockets: Two (512K x 16) DMA: Two channels Capacity: 2MB Clock Speed: 8 MHz or 25 MHz Access Cycles: Six read, seven write Module Types: Two single-high, one double-high Flash (120ns) Transfer Rate, 8 MHz: 8MB/sec 16-bit; 16MB/sec 32-bit Capacity: 1MB Connectors: Access via two 50-pin planar connectors Access Cycles: Five read, six write 2 MVME162PA2 SCSI Bus Power Requirements (no IP Modules) Controller: NCR 53C710 Typical Maximum Local Bus DMA: Yes, with local bus burst +5V ± 5%: 1.75 A 2.25 A Asynchronous: 5.0MB/s +12V ± 5%: — 100 mA (max., with off- board LAN transceiver) Synchronous: 10.0MB/s –12V ± 5%: 100 mA — Connector: Front-panel 68-pin micro D high density Board Size Ethernet Height: 233.4 mm (9.2 in.) Controller: 82596CA Depth: 160.0 mm (6.3 in.) Local bus DMA: Yes Front Panel Height: 261.8 mm (10.3 in.) Connector: Front-panel DB-15 Width: 19.8 mm (0.8 in.) Asynchronous Serial Ports Demonstrated MTBF Controller: Two, 85230 (based on a sample of eight boards in accelerated stress environment) Number of Ports: Four Mean: 190,509 hours Configuration: EIA-232-D DTE (all four ports) 95% Confidence: 107,681 hours Async Baud Rate: 38.4Kb/s max. Sync Baud Rate: 38.4Kb/s max. Environmental Connectors: Front-panel RJ-45 Operating Nonoperating Counters/Timers Temperature: 0° C to +55° C, –40° C to +70° C forced air cooling Real-Time Six 32-bit, 1 µsec resolution Humidity (NC): 5% to 85% 5% to 95% Timers/Counters: Vibration: 0.5 G 6 Gs TOD Clock Device: 8KB NVRAM; MK48T58 20–2000 Hz random 20–2000 Hz random Watchdog Timer: Time-out generates Reset Safety Hardware Support All printed wiring boards (PWBs) are manufactured with a flammability Multiprocessing Four mailbox interrupts, RMW, shared rating of 94V-0 by UL recognized manufacturers. Hardware Support: RAM Electromagnetic Compatibility (EMC) Debug/Monitor: MVME162FW, boot and diagnostics Intended for use in systems meeting the following regulations: U.S.: FCC Part 15, Subpart B, Class A (non-residential) Canada: ICES-003, Class A (non-residential) This product was tested in a representative system to the following standards: CE Mark per European EMC Directive 89/336/EEC with Amendments; Emissions: EN55022 Class B; Immunity: EN55024 MVME162PA2 3 Ord erin g In formatio n ORDERING INFORMATION Part Number Description MVME162PA-252SE 25 MHz MC68040, 32MB SDRAM, SCSI, Ethernet Documentation V162PLXA/IH MVME162P2 Installation and Use Manual V1X2PLXA/PG MVME162P2/172P2 Programmer’s Guide V162DIAA/UM1 162Bug Diagnostics User’s Manual 68KBUG1/D 68K Debugging Package User’s Manual Part 1 68KBUG2/D 68K Debugging Package User’s Manual Part 2 Documentation is available for online viewing and ordering at http://www.motorola.com/computer/literature Motorola Computer Group NORTH AMERICA: Tempe, AZ 800-759-1107 or 602-438-5720 ASIA: Shanghai, China +86 21 5292 5693 Regional Offices EUROPE: Loughborough, UK +44 1509 634300 PACIFIC RIM: Tokyo, Japan +81 3 5424 3101 EAST MEDITERRANEAN: Tel Aviv, Israel +972 3 568 4388 ASIA/PACIFIC: Hong Kong +852 2966 3210 www.motorola.com/computer MOTOROLA and the Stylized M Logo are registered in the U.S. Patent and Trademark Office. All other product or service names are the property of their respective owners. This datasheet identifies products, their specifications, and their characteristics, which may be suitable for certain applications. It does not constitute an offer to sell or a commitment of present or future availability, and should not be relied upon to state the terms and conditions, including warranties and disclaimers thereof, on which Motorola may sell products. A prospective buyer should exercise its own independent judgement to confirm the suitability of the products for particular applications. Motorola reserves the right to make changes, without notice, to any products or information herein which will, in its sole discretion, improve reliability, function, or design. Motorola does not assume any liability arising out of the application or use of any product or circuit described herein; neither does it convey any license under its patent or other intellectual property rights or under others. This disclaimer extends to any prospective buyer, and it includes Motorola’s licensee, licensee’s transferees, and licensee’s customers and users. Availability of some of the products and services described herein may be restricted in some locations. 162IP-D4 02/03 © 2003, 2001, 2000 Motorola, Inc. All rights reserved.