» VM6250 « 6U VME High Performance PowerPC Computer » Up to 1.33 GHz Freescale Dual-Core MPC8641 with AltiVec » Support for XMC and PMC Modules » Air and Conduction-Cooled Releases » Operating from -40°C to +85°C » Linux Fedora 9 and VxWorks 6.x Support The pulse of innovation to P1 to P1 1 1 Kontron Datasheet 6U VME High Performance PowerPC Computer V VM ME Eb bu us s P P1 1 ( ( ( ( (5 5-r ro o o ow w w) ) ) ) ) ) V VM ME Eb bu us s P P2 2 ( ( ( (5 5-r ro ow w) ) ) ) P P0 0 The VM6250 is built around Freescale’s state-of-the-art MPC8640/8641 single or dual-core e600 processor. The VM6250 provides exceptional I/O capabilities onboard and outstanding USB USB 4x GBE 4x GBE Flash Flash P PHY HY flexibility by being the first 6U VME board to provide support for PMC and XMC mezzanine cards. The VM6250’s high performance, 2eSST, P P PM M MC C C 1 1 1 P PM MC C 2 2 6 64 4 4/ /1 10 00 0 M MH Hz z 3 32 2/ /6 66 6 M MH Hz z USB USB VME interface helps customers preserve their investment in legacy F Flla as sh h VME equipment. The VM6250 was designed to be Kontron’s next n n nv vS SR RA AM M PCI-E/ PCI I-E/ PCI-E/ PCI-E/ / generation VME SBC providing substantial price and performance Dual Dual PC PCI32 I I I32 PCIx PCIx E E EE EP PR RO OM M P PCI-E/ CI-E/ S Sata ata A AL LM MA A V VM ME E Bridge Brid dg ge Bridge Bridg ge e advantages over previous generations of VME computers. PCI32 PCI32 PCI32 x1 x x x1 x x x1 2 2e eS SS ST T Bridge Bridg ge x x4 x x4 x4 4 4 4 4 4 x4 x x4 4 x1 x1 MPC8640/8641 x4 x4 4 Powerful Freescale MPC864x PowerPC Architecture P PC CI I- -E E Single/Dual x4 x4 x1 x1 x1 S Sw wi it tc ch h 1-1.33 GHz The MPC864x processors feature an AltiVec engine to perform 128-bit wide parallel processing instructions (SIMD), and a four x1 x1 channel DMA controller to accelerate data transfers. In order FPG FPGA A to fill all the requirements with the best compromise between performance and power dissipation, the VM6250 is available in several different configurations. It can be equipped with a MPC8640 single or dual processor at frequencies of 1 GHz EIA-232 ABORT DUAL ETHERNET USB 2.0 and 1.25 GHz or with a MPC8641 single or dual processor at a RESET frequency of 1.33 GHz. Soldered DDR2 Memories with ECC Support 1  The MPC864x provide DDR2 memory controllers operating at up       RST L1 L2 L3 L4 1 0 USB to 533 MHz with 72-bit wide DDR2 SDRAM configured with 8 bits L5  of Error-Correcting Code (ECC). The peak memory bandwidth is 4.3 GB/s. Software Numerous Storage Interfaces The VM6250 is delivered with PowerOn Built-in-tests and the OpenSource 128 KB of Auto-store, Non-Volatile Random Access Memory allows U-Boot firmware. The VM6250 supports Wind River’s VxWorks 6.x Real backup of critical data when power is removed. Dual redundant 32 Mb Time Operating System Software and Fedora 9 Linux distributions. NOR Flash are used to store firmware code and built-in tests, and two Consult factory for other O/S support. serial 64-Kbit EEPROMs are dedicated to system and application data storage. A USB 2.0 Flash drive slot is available onboard supporting low 10-year Long Life Cycle profile USB 2.0 Flash disk modules up to 8 GB. One dual SATA II and Investing in a new project is always a challenge and risky. Maximizing two USB 2.0 ports are also available on the P0 backplane connector. the lifetime of an application is therefore a critical issue when it The VM6250 is equipped with the Alma VME controller supporting the comes to saving development investments. The VM6250 has been VME64x and 2eSST protocols offering up to 320 MB/s peak throughput. designed with long life cycle components. Beyond the use of standard commercially available components, Kontron offers Longevity of Supply Backplane Switch services which are designed to make the VM6250 available for ten years Two compliant VITA 31.1 Gigabit Ethernet links are available on P0 or longer. connector. In addition, one 4x PCI Express link is available on P0, which, optionally may be configured as one 4x Serial RapidIO link. Designed to meet the Requirements of Harsh Environments The VM6250 has been designed using the same PCB for both air and Extensive I/O connectivity conduction-cooled boards. Build variants span a complete range of The VM6250 provides up to four 10/100/1000BASE-TX Ethernet temperature, shock and vibration requirements as specified in the VITA interfaces, two EIA-232 serial lines, five general purpose I/Os, three 47 standards. USB 2.0 links, two SATA II interfaces and one 4x PCI-Express link. Two SATA Disk Carrier onboard Mezzanine Sites support PCI and PCI-Express cards. For applications where large and high speed data storage is necessary, Legacy Compatibility the VM6250 is available in a version with an onboard SATA connector allowing a SATA disk carrier to be mounted directly on the board, saving The VM6250 has been designed to offer legacy I/O compatibility with on an external storage device. This disk carrier (KIT-DISK25-SATA) is the Kontron’s VMPC6x and PowerEngine7 boards to provide for an easy mounted over the right-hand mezzanine slot. path for technology insertion into existing systems. 2 www.kontron.com D D DD DR R2 2 U Up p t t to o 2 2G GB B VME / 2eSST Dual USB 2.0 Dual Gigabit Ethernet Dual SATA RESET PWRDN 4x GPIOs 32 I/Os PMC 1 x4 PCI-E / SRIO links 64 I/Os PMC 2 32 I/Os PMC 1 2x EIA-232  Kontron Datasheet PowerPC x86 PENTXM2, VM6050 VM6250 Pinout Compatibility across Silicon Families » Mezzanine Carrier » Rear Transition Module » Front Panel I/Os Technical Information System Processor and Chipset Processor Freescale MPC8641 or MPC8640 single/dual-Core PowerPC Processor operating from 1 GHz up to 1.33 GHz Cache Structure L1 cache: 32 KB Data + 32 KB Instruction ; L2 cache: 2 x 1 MB Gigabit Ethernet Controller Four 10/100/1000 Mbps Ethernet/IEEE®802.3 networks controllers Memory Controller Integrated DDR2 memory controller with ECC support, up to 533 MHz, 72-bit UARTs 2x UART, 16550-style, 4-wire, integrated in MPC864x Memory System Memory Up to 2 GB DDR2 SDRAM up to 533 MHz, 64-bit wide + ECC, soldered Firmware Boot device 2x up to 32 Mb soldered NOR fl ash for Uboot, redundant boot device NAND Flash Up to 8 GB USB Nand Flash modules socket NOVRAM 1x 128 KB of NOVRAM (Simtek/Cypress) EEPROM 2x serial EEPROM Onboard Controllers Watchdog 2x Watchdog timer with programmable timeout RTC RV-8564-C2 from Micro-Crystal Gigabit Ethernet PHY Broadcom BCM5466R, low-power QUAD Gigabit Ethernet Transceiver SATA Controller 1x Dual SATA II Controller Sil3132 USB Controller 2x Dual USB 2.0 Controller NXP ISP1562 VME Controller Alma VME Controller (2eSST supported) Extension PMCs Carrier board V2PMC2 carrier board supported for two additional PMCs Rear Transition Module 6U VME RTM for backplane I/Os extension Rear I/O via P0 & P2 Gigabit Ethernet 2x 10/100/1000BASE-TX on P0 (VITA 31.1) PCI Express or Serial RapidIO x1/x4 PCI Express 1.0 on P0 (Default) or x1/x4 serial RapidIO on P0 (multiplexed with PCIe) (Build Option) USB & SATA Ports 2x USB 2.0 & 2 x SATA II Ports on P0 Serial Ports 1 / 2 Serial Ports on P2 PMC I/Os PMC 2 - VITA 35 P4V2-64ac on P2, PMC1 - fi rst 32 VITA 35 P4V2-46dz PMC I/Os on P2; second 32 PMC I/Os on P0 GPIO 4x GPIO on P0 Front Panel Interfaces Gigabit Ethernet 2x 1000BASE-TX on RJ-45 connectors Serial Port 1 EIA-232 UART interface, RJ-11 connector. USB Port 1 USB connector Reset Reset button PMC/XMC 2x PMC or XMC slots x1/x4 serial RapidIO Build Options Software Power-on Built-In-Tests testing over 95% of board features Uboot Firmware 1.3.3 release Real Time Operating System VxWorks 6.x Board Support Package – Consult factory for other O/S and versions Linux Operating System Fedora 9 Board Support Package 3 www.kontron.com Kontron Datasheet Technical Information Power Power needs: 3.3V, 5V (+12/-12V if required for mezzanine) Power consumption Single: Max. / Typ. Dual: Max. / Typ. MPC8640 1.00 GHz 33W / 27W 41W / 31W MPC8640 1.25 GHz 41W / 39W 53W / 43W MPC8641 1.33 GHz 44W / 38W 60W / 45W Standard Air-Cooled Version: 430g approx. / Conduction-Cooled Version: 700g approx. Weight Environmental Specifcation SA WA RA RC Standard Commercial Extended Temperature Rugged Air-Cooled Rugged Conduction-Cooled Conformal Coating Optional Standard Standard Standard Airfl ow 1.2 m/s 1.5 m/s 1.8 m/s NA Temperature VITA 47-Class AC1 VITA 47-Class AC2 VITA 47-Class AC3 VITA 47-Class CC4 Cooling Method Convection Convection Convection Conduction Operating 0° to +55°C -20° to +65°C -40° to +71°C -40° to +85°C Storage -45° to +85°C -45° to +85°C -45° to +100°C -45° to +100°C Vibration Sine (Operating) 20-500 Hz - 2g 20-500 Hz - 2g 20-2,000 Hz - 3g 20-2,000 Hz - 5g VITA 47-Class V1 VITA 47-Class V1 VITA 47-Class V2 VITA 47-Class V3 Random Shock (Operating) 20g/11 ms Half Sine 20g/11 ms Half Sine 40g/11 ms Half Sine 40g/11 ms Half Sine Altitude (Operating) -1,500 to 60,000 ft -1,500 to 60,000 ft -1,500 to 60,000 ft -1,500 to 60,000 ft Relative Humidity 90% without condensation 95% without condensation 95% without condensation 95% without condensation Ordering Information Order Code Description Article Fast Track Order Code deliverable in less than 15 days: VM6250-1SA24-10110 Air-Cooled version, Single Core MPC8640 @ 1GHz/533MHz, 1GB DDR2 SDRAM, 128k NVRAM, 2 PMC slots VM6250 EZ1-VM6250 EZ1-VM6250 Turnkey evaluation and development platform VM6250 options: make your choice ! > Class: SA, WA, RC. Class RA on project request > Memory: 1GB, 2GB > Processor: Single and Dual Core MPC8640/MPC8641 > Mezzanine slots: 2 PMC, 2 PMC/XMC, onboard SATA connector > CPU Frequency: 1GHz, 1.25GHz, 1.33GHz > Conformal Coating Please contact Kontron GSS-ATD-Toulon@kontron.com or your Kontron Sales representative to defi ne the version fi tting your requirements. Conduction cooled SATA Disk PMCs carrier Rear Transition ASSOCIATED PRODUCTS Carrier Module Evaluation System EZ1-VM6250 VM6250-RC PBV36-P0-VM6-00 KIT-DIS25-SATA V2PMC2 CORPORATE OFFICES Europe, Middle East & Africa North America Asia Pacifi c Oskar-von-Miller-Str. 1 14118 Stowe Drive 17 Building,Block #1, ABP. 85386 Eching / Munich Poway, CA 92064-7147 188 Southern West 4th Ring Road Germany USA Beijing 100070, P.R.China Tel.: + 49 8165 77 777 Tel.: + 1 888 294 4558 Tel.: + 86 10 63751188 Fax: + 49 8165 77 219 Fax: + 1 858 677 0898 Fax: + 86 10 83682438 info@kontron.com info@us.kontron.com info@kontron.cn 4 www.kontron.com Datasheet – VM6250 #07242014MB All data is for information purposes only and not guaranteed for legal purposes. Subject to change without notice. Information in this datasheet has been carefully checked and is believed to be accurate; however, no responsibilty is assumed for inaccurancies. All brand or product names are trademarks or registered trademarks of their respective owners.