Climatic Humidity

93% RH at 40°C, non-condensing (acc. to IEC 60068-2-78)

CompactPCI Bus Interface

PICMG 2.0 Rev. 3.0 compatible, 32-bit, 33/66MHz system master, universal 5V and 3.3V PCI signalling voltage supported, 4 Req/Gnt & clock lines

Compliancy

CompactPCI Core Specification PICMG 2.0 Rev. 3.0, ANSI/VITA47-2005:, CP3002-RC ECC4, CP3002-RA EAC6 planned, Designed to meet or exceed: Safety: UL 60950-1, CSA 22.2 No 60950-1, EN60950-1, EMI/EMC: EN 55022 / EN 55024, EN 50081-1 / EN 61000-6-2

Dimensions

100 x 160mm, 3U, 4HP

EEPROM

Serial EEPROM (24LC64) 64 Kbit for storing uEFI BIOS settings and serial number

Flash (uEFI)

2x redundant 8 MB SPI Flashes, with fail-over functionality

Gigabit Ethernet

4x GbE, without onboard magnetics, Intel 82580EB Quad Gigabit Ethernet controller, WOL (Wake-On-LAN) support

I/O Extension Connector

The I/O extension connector holds 1x SATA port for mounting the SATA NAND Flash module

LED's

LED 0,1,2,3: POST Code or General Purpose or WD, TH

MTBF

CP3002-RC 261,450 h acc. to MIL-HDBK-217FN2, Ground Benign, controlled at 30°, CP3002-RA 234,213 h acc. to MIL-HDBK-217FN2, Ground Benign, controlled at 30°

Operating Temp.

-40 °C to +85 °C, CP3002-RC without TPM, -40 °C to +75 °C, CP3002-RA without TPM, -25 °C to +70 °C, CP3002-RC/-RA with TPM

Platform Controller Hub

Mobile Intel QM57 Express Chipset: SATA host controller with six ports with RAID 0/1/5/10 support, (only 3x ports are used, thus only RAID 0/1/5 support is available), USB 2.0 host interface with up to 14 ports (only 2x ports are used), 2x PCI Express x4 or 8x PCI Express x1 2.0 ports (only 1x PCI-Express x4 is used

Power Consumption

Typ. 31W

Processor

Intel Core i7
Intel Core i7 processor (32nm manufacturing process): Core i7-620LE: 2.0 GHz, LV, 4MB L3 cache (shared instruction/data cache between both cores), Please contact Kontron for further information concerning the suitability of other Intel processors for use with the CP3002-RC/-RA.

RTC

Integrated in QM57 with 256 Byte CMOS RAM

SATA NAND Flash

Up to 32 GB SLC NAND Flash on a dedicated SATA NAND Flash module

Software Support

AMI uEFI, setup console redirection to serial port (VT100 mode) with CMOS setup access, EFI Shell support, Board configuration via Shell, diskless, keyboardless, videoless operation, LAN boot support, Board identification number accessible via EEPROM, Support for Windows® XP, Windows® 7, Windows® Embedded Standard 7, Windows® Server 2003, Windows® Server 2008, Linux®, Wind River Linux, VxWorks®, QNX® (Other OSs may also be used with the CP3002-RC/-RA. Please contact Kontron for further information.)

Storage temp.

-55°C to +85ºC (without additional components)

Supervisory Functions

Watchdog, software configurable, 125ms to 4096s in 16 steps, generates IRQ or hardware reset, dual-stage configuration

System Memory

Up to 8 GB DDR3 SDRAM running at 1066 MHz, soldered, with ECC

Trusted Platform Module (TPM)

Infineon SLB9635TT TPM 1.2 controller, optional

UART

XR16L2750IM-F, dual UART, 16C550-compatible

VGA

High performance 3D graphics controller integrated in the processor: Supports analog display resolutions up to 2048 x 1536 pixels @ 75Hz, Dynamic Video Memory Technology (DVMT), up to 352 MB

Watchdog

FPGA-based, timeout ranging from 125ms to 4096s programmable in 16 steps, IRQ, Reset, dual-stage

Weight

CP3002-RC: 342 g (without mezzanine card), CP3002-RA: 403 g (without mezzanine card)